|
Product information: page 1 (140 kB, jpg), page 2 (152 kB, jpg).
click to enlarge | D2000 cordless curing light | Fast LED curing light.
combo of cordless & cord LED curing light
built-in digital meter
fast, ramp & pulse mode
cold light, never heats up, no fan
small, light, compact |
LED CURING LIGHTS
This Light Emitting Diode curing light, has the power equal to a 1200mw/cm2 halogen light. It cures 3mm of Spectrum in 5 seconds on F setting. This semiconductor optical device has an array of blue light emitting diodes set to 430~490 nm.
The blue light produced is a very narrow band width which corresponds closely to the peak light absorption of the photo initiator camphorquinone found in most light activated materials. As the light generated is blue light rather than filtered white light, the light is much more efficient than halogen curing units. This can be seen if you compare the light output on a light meter of this unit to a standard halogen bulb, the light output would appear to be less. However check the depth of cure of composite, it is much greater.
ADVANTAGES OF D2000 CURING LIGHT
The D-2000 sits in a holder that operates as a combination battery recharger and digital light meter. The light ergonomic handpiece contains a 5W LED lamp. The D2000 is quiet in operation, and even after extended use, the end of the light guide will never heat up. The diodes should not have to be changed during the expected working life of the light. Their life is on average the equivalent of 4 years continuous use.
EASY TO USE
The D2000 controls are easy to use. M switches the unit between operating modes. S adjusts the cure time on a pre calibrated scale of 5, 10, 20, 30, 40, 60 and 99 seconds. O is the on / off switch.
ADVANCED FEATURES
D2000 unit has three operating modes F, R and P, Fast, Ramp, and Pulse. F mode starts the unit on full power for the duration of the cure time set. R mode gradually ramps the power up to full over 2 seconds, and then continues at full power for the remainder of the cure time set. P pulses the light at full power for a second with a rest of 0.2 seconds for the duration of the cure time set.
WARRANTY
One year on the unit and charger with the exception of the light guide and cure tips. The warranty on the light guide and cure tips is limited to 1 month from date of purchase.
ACCESORIES:
1. Charger (built-in meter): 1pc
2. Light guide: 1 pc
3. Cure shield: 1 pc
4. Li-Ion battery: 1 pc
TECHNICAL SPECIFICATION:
| Curing hand piece - light source: | Hi-Flux 5W LED |
| Curing hand piece - light power: | equal to halogen 1200mw/cm2 |
| Curing hand piece - wave length: | 430-490 nm |
| Curing hand piece - light guide: | 8 mm, glass |
| Battery - type: | Li-Ion |
| Battery - voltage: | DC 3.7V |
| Battery - capacity: | 1900 mAh |
| Battery - dimension: | D18 x L65 mm |
| Adapter - input: | AC 100V - 240V, 0.3A |
| Adapter - output: | DC 5V, 2A |
| Adapter - frequency: | 50/60Hz |
| Charger - weight: | 275g |
| Charger - dimensions: | W71 x L90 x H40 (mm) |
|
